Installation manual
29
3.1.2
Levelling the machine :
Adjust the nuts with a spanner and adjust the dryer ironer so that it is horizontal and that its four stands are perfectly
vertical.
Check with a spirit level placed on the sole plate for the longitudinal direction and the machine top cover for the trans-
verse direction (see below)
The maximum stand height adjustment is 80 mm (3")
Tighten the lock nuts after adjustment for each pads.
Caution
Leave a minimum space of 5 mm between the floor and the cases , The ironer must be on its four adjustable feet.
3.1.3
Machine with optional suction feeding table
The machine can be equipped with a suction engagement table to allow better guidance of the sheet at the
engagement
. It operates with 2 fans located under the dryer, attached to the front or the rear spar (depending of your model).
Use a wrench to adjust the nuts (2) and adjust the feet (1) of the suction fan brackets located under the dryer.
After adjustment, lock the locknuts.