Electrolux Professional IC6 48 FFS Series Installation Manual page 24

24
If this type of tool is unavailable, follow the procedure in the next chapter to remove the pallet from the machine.
3.1.1.2 Remove the pallet without a two-wheel forklift load :
Equipment :
• 01 x hydraulic cylinder
• 24 x piece of wood (400x70x60)
• 08 piece of wood (400x150x25)
• 1 side new support / 1 side old support
• 1 new pallet that does not exceed the machine.
STEP 1 :
• Check that all the nails of the pallet are well in the wood so as not to come up against the wooden wedges when
removing the pallet.
• Lift the right of the machine (facing the machine) with the hydraulic cylinder. Attention to the location of the hy-
draulic cylinder, put it a little on the left of the axis of the cylinder (1) to remain stable and not lean.
Installation manual