Electrolux Professional IC6 48 FFS Series Installation Manual page 28

28
A delta of 45 mm is obtained between the two sides of the machine.
STEP 10 :
• Lift the machine and remove from the left side the wedge (400x70x60) 70 mm thick
Right side : 1 (400x150x25) = 25 mm.
Left side : machine on the ground.
A delta of 25 mm is obtained between the two sides of the machine.
STEP 11 :
• Lift the machine and remove from the right side the wedge (400x150x25) 25 mm thick
The machine is on the ground.
Note : with older transport brackets this works too and there is no need to disassemble them. The new ones go
lower than the cranckcase and it is imperative to dismount them to put the machine on the ground.
Installation manual