• The strength of the adhesive is fairly weak to prevent the paint on the frame from being peeled off when removing the electric wire cover/cord cover,
such as when replacing the electric wires. If the electric wire cover/cord cover is peeled off, replace it with a new one. When removing the electric wire
cover/cord cover, do not peel it off too vigorously. Otherwise, the paint on the frame will peel off, too.
Cord clip
• EW-CL300-S is marked with a groove in order to differentiate it from EW-CL300-M.
Conversion adapter
• A conversion adapter (EW-AD305) is required to connect the EW-SD50 to a component with an E-TUBE port for the EW-SD300.
Conversion adapter (EW-AD305)
Electric wire (EW-SD300)
Dual control lever
• Dummy plugs are installed at the time of shipment from the factory. Do not remove them except when necessary.
• When routing the electric wires, take care to ensure that they do not interfere with the brake levers.
SM-BMR1/Battery mount
• This is supported by the firmware versions 2.0.0 and later.
The actual product may differ from the illustration because this manual is intended mainly to explain the procedures for using