Shimano ALFINE S7051 Series Dealer's Manual page 16

TO ENSURE SAFETY
For Installation to the Bicycle, and Maintenance:
„Notes on reinstalling and replacing components
• When the product is reassembled or replaced, it is automatically recognized by the system to allow operation according to the settings.
• If the system does not operate after reassembly and replacement, follow the system power reset procedure below to check the operation.
• If the component configuration changes or malfunction is observed, use the E-TUBE PROJECT software to update the firmware of each component to
the latest version and perform a check again. Also make sure that the E-TUBE PROJECT software is the latest version. If the software is not the latest
version, the component compatibility or the product functions may not be available.
Be sure to also inform users of the following:
„About used batteries
• Lithium-ion batteries are recyclable, valuable resources.
„About system power reset
• When the system fails to operate, the system may be recovered by resetting the system power.
• Remove the battery and wait about one minute. Then re-mount the battery.
In the case of using SM-BTR1
• Remove the battery from the battery mount. After about one minute, install the battery.
In the case of using SM-BTR2 / BT-DN110 / BT-DN110-A
• Disconnect the plug from SM-BTR2 / BT-DN110 / BT-DN110-A. After about one minute, insert the plug.
„Connection and communication with PC
• PC linkage devices can be used to connect a PC to the bicycle (system or components), and E-TUBE PROJECT Professional can be used to carry out tasks
such as customizing single components or the whole system and updating their firmware.
If your version of E-TUBE PROJECT Professional and the firmware for each component are not up to date, there could be problems operating the
bicycle. Check the software version and update it to the latest one.
„Connection and communication with smartphone
• E-TUBE PROJECT Cyclist can be used to carry out tasks such as customizing single components or the whole system and updating their firmware, after
connecting the bicycle (system or components) to a smartphone via Bluetooth
• Disconnect the Bluetooth
®
Using a system information display without disconnecting the Bluetooth
About compatibility with E-TUBE PROJECT
• For details on compatibility with E-TUBE PROJECT, refer to the following website.
(https://bike.shimano.com/e-tube/project/compatibility.html#guide_list)
LE connection when not using E-TUBE PROJECT Cyclist.
LE.
®
LE connection could increase battery consumption.
®
16