Integrated Laser Aimer (Sh4-14/30-Xxxx-A-X-X Models Only); Integrated Led Aimer (Sh4-2/3/4-Xxxx-A-X-X Models Only) - Datasensing SH4 ADVANCED Product Reference Manual

INTEGRATED LASER AIMER (SH4-14/30-XXXX-A-X-X
MODELS ONLY)
A class 2 laser aimer can be used to verify the alignment of the light curtain in long dis-
tance, or with several deviating mirror.
The aimer is positioned on the front of the Emitter light curtain (see "Overall Dimen-
sions" on page 108 for more details) and can be activated by connecting the pin 2 (TEST/
AIMER) to the pin 5 (COM) (see "Electrical Connection" on page 26).
INTEGRATED LED AIMER (SH4-2/3/4-XXXX-A-X-X MODELS
ONLY)
A LED aimer can be used to verify the alignment of the light curtain in long distance, or
with several deviating mirror.
The aimer is positioned on the front of the Emitter light curtain (see "Overall Dimen-
sions" on page 108 for more details) and can be activated by connecting the pin 2 (TEST/
AIMER) to the pin 5 (COM) (see "Electrical Connection" on page 26).
LED aimer needs included reflective target to be visible at long distances. As per reflec-
tive target characteristics maximum visibility is achieved staring at the reflector from
behind the LED aimer.

INTEGRATED LASER AIMER (SH4-14/30-XXXX-A-X-X MODELS ONLY)

NOTE: The Laser aimer is automatically switched off after 30 minutes from
startup.
NOTE: Laser aimer may only be used as visible indication of where emitter
IR beams are directed so to adjust emitter rotation along its vertical axis.
It's not granted that if laser beam is targeted on receiver unit TX and RX
are perfectly aligned. Please refer to "Alignment Procedure" on page 49
for correct alignment procedure.
NOTE: The LED aimer is automatically switched off after 30 minutes from
startup.
Infra-red breams
Reflective target
Red LED beam
PRODUCT REFERENCE GUIDE
53