Ricoh IM 2500 Series User Manual page 297

• Check whether the name in "Group" is correctly specified including the case-sensitivity in [Settings]
[System Settings]
Authentication/User Authentication/App Auth.]
[Windows Authentication].
• Select the user in the address book, press [Edit], and then check that [Unavailable] is specified for
each function under the [User Management / Others] tab
Functions / Applications].
• Check whether "Global Scope" is specified as the scope of the group in a property for the user
group created in DC, and the group type specified in "Security". Also check whether an account is
registered to the user group that has been created. If more than one DC exists, check whether a
trust relationship between DCs is established.
*2 To resolve the domain name, see the following:
• Check whether [Domain Name Configuration] and [DNS Configuration] or [WINS Configuration]
is specified correctly in [Settings]
• Enter the IP address in [Domain Name Configuration] to check the connection. If authentication can
be performed using the IP address, check [DNS Configuration] or [WINS Configuration] again.
• If authentication by IP address is not possible, check whether LM/NTLM is set to be denied in the
domain controller security policy or domain security policy. Also check that the port is not closed in
the firewall between the device and the domain controller or in the firewall settings of the domain
controller. When the Windows firewall is enabled, create a new rule that allows communication on
port 137 and port 139 in "Advanced" of the Windows firewall. Open the TCP/IP properties from
the network connection properties, select the "Enable NetBIOS Over TCP/IP" check box on
[Advanced] [WINS] tab, and open port 137.
*3 For Kerberos authentication, check the following:
• Check that "Realm Name", "KDC Server Name", "Domain Name" are specified correctly in
[Settings] [System Settings]
[Administrator Authentication/User Authentication/App Auth.]
Realm]. Enter "Realm Name" in upper case.
• Configure the setting so that the difference in time between the clocks on KDC and device is less
than five minutes. The clock on the machine can be adjusted in [Settings]
[Date/Time/Timer]
• Kerberos authentication fails if auto-obtaining of KDC in Windows authentication fails. When auto-
obtaining cannot be activated, switch to manual.
*4 For LDAP settings, check the following:
• Check whether the LDAP server is correctly specified in [Settings]
for Administrator]
Authentication/App Auth.]
[Custom Authentication].
[Settings for Administrator]
[System Settings]
[Settings for Administrator]
[Date/Time] [Set Time].
[Authentication/Charge]
[User Authentication Management]
When Other Messages Appear
[Authentication/Charge]
[User Authentication Management]
[User Management]
[Network/Interface].
[Authentication/Charge]
[Register/Change/Delete
[System Settings]
[Administrator Authentication/User
[LDAP Authentication] or
[Administrator
[Available
[System Settings]
[Settings
295