Advertisement
STEP 1: (VEHICLE PREP)
Park vehicle in a location accessible by an
1.1
overhead hoist.
1.2 Disconnect the negative battery terminal.
1.3 Remove screw and P-Clamp found on the engine
holding wire harness in place. See Fig. 1.3.
Tools required
13mm socket
1.4 Remove cover and grille from vehicle. Set aside
grille for later re-work and keep all removed
mounting hardware . See Fig. 1.4.
Tools required
T25 Torx Bit
1.5 Per Figure 1.5, cut off the right flange of grille at
marked edge. Apply touch-up paint to the cut
edges.
Tools required
Cut-Off Wheel or Jigsaw
1.6 Remove right fender.
Remove sleeve and retainer and set aside for later
re-installation. Remove bracket and M8X1.25
Lock Nut. See Figures 1.4 & 1.6
Remove Torx fasteners around instrument panel
Remove two fasteners securing the bottom of the
fender.
Tools required
T25 Torx Bit
10mm socket or wrench
13mm socket and wrench
CAB INSTALLATION
Remove
Fig. 1.3 (Remove Screw and P-Clamp)
Grille
Fig. 1.4 (Remove Cover and Grille)
Cut Grille Here
Fig. 1.5 (Cut Right Flange of Grille off)
Remove Bracket
Remove Nut
Remove Right Fender
+ Set Aside
Fig. 1.6 (Remove Right Fender)
4 of 34
Right
Fender
Cover
Remove + Set Aside
Retainer & Sleeve
Advertisement
