Advertisement
STEP 2: (CAB INSTALLATION)
2.18 Place the rear panel assembly onto the R.O.P.S.
brackets apply pressure towards the AC Unit.
Install the top horizonal screws first and then the
(4) screws in two rear fillers. Attach to the
previously installed Velcro. See Figure 2.18.
Hardware Used
1/4-20X5/8" Flange Hex Screw
1/4-20X3/4" Flange Hex Screw
1/4-20 Flange Lock Nut
Tools required
3/8" wrench or socket
7/16" wrench or socket
2.19 At the bottom of the left side rear panel assembly
there is a small piece of Velcro. Place a piece of
P.S.A. Velcro onto the rear fender as shown in
Figure 2.19. Attach lower corner of rear panel
vinyl onto installed Velcro.
Tools required
Scissors
2.20 Once the rear panel's vinyl filler is fully installed
onto the mating Velcro, install hardware through
the Vinyl into the (2) fillers. See Figures 2.20a
and b. Do not over tighten or vinyl will be
damaged.
Hardware Used
1/4-20X3/4" PH Truss Head Screw 2
1/4-20 Flange Lock Nut
Tools required
#3 Phillips Head Screwdriver
7/16" wrench or socket
Install Screw through
Vinyl and Rear Filler.
Phillips Head on
Inside of cab.
Fig. 2.20b (Attach Rear Filler Vinyl to Right Filler)
CAB INSTALLATION
Qty
4
2
6
Qty
2
Install 1/4-20X3/4"
First
Install 5/8" lg.
last
Fig. 2.18 (Install Rear Panel Assembly)
Fig. 2.19 (Install Velcro, Left Fender)
Install Screw through
Vinyl and Rear Filler.
Phillips Head on
Inside of Cab.
Fig. 2.20a (Attach Rear Filler Vinyl to Left Filler)
17 of 34
Apply
Velcro to
Left Fender
Advertisement
