Advertisement
STEP 2: (CAB INSTALLATION)
Remove the doors from the cabin and set aside
2.1
carefully to prevent scratching the panels.
2.2 Lower the mower deck to 2"
2.3 Position a lifting strap so that it sits roughly 7-1/2"
behind the gas shock mount as shown in Figure
2.3.
2.4 Put tension on the lifting strap with the overhead
hoist. Remove and discard the (4) bolts holding
the rear of the cab down to the rear shipping
bracket (located inside the cab) as well as the (4)
bolts holding the floorboards to the front shipping
brackets. See Figures 2.4a, b, and c.
Tools required
1/2" wrench or socket
2.5 With assistance, lift the cabin and position over
the vehicle. Be sure to support the A/C
compressor so that it never hangs from the hoses.
2.6 Lower the cab slowly onto the vehicle being
careful to not scratch the fenders with the rear
edge of the floorboards.
CAB INSTALLATION
Fig. 2.3 (Position Lifting Strap)
Overhead Hoist
Fig. 2.4a (Tension Lifting Strap)
Remove
Fig. 2.4b (Remove Front Shipping Bracket Bolts)
Remove
Fig. 2.4c (Remove Rear Shipping Bracket Bolts)
13 of 34
Advertisement
