Advertisement
STEP 2: (CAB INSTALLATION)
2.7 Install the back of the cab to R.O.P.S mounts per
Figure 2.7.
Hardware Used
5/16-18X1-3/4" Flange Hex Screw
5/16-18 Flange Lock Nut
Tools required
1/2" wrench and socket
2.8 Install the front of the cab to front mounts per
Figure 2.8.
Hardware Used
5/16-18X1" Flange Hex Screw
5/16-18 Flange Lock Nut
Tools required
1/2" wrench and socket
2.9 Fully tighten front mount hardware going into the
vehicle's side frame. Torque to 110 ft-lbs. (150
Nm). See Figure 2.9.
Tools required
18mm wrench
18mm socket
Torque Wrench
2.10 Install one of the supplied brushes to the
underside of the right cab floorboard.
Next, install a second brush along with the
supplied floorboard insert on the inboard side of
the deck lift lever. See Figure 2.10.
Hardware Used
#8-32 X5/8" Pan Head Screw
#8-32 Flange Lock Nut
Tools required
11/32" wrench or socket
#2 Phillips bit or screw driver
CAB INSTALLATION
Qty
4
4
Qty
4
4
Qty
6
6
Fig. 2.7 (Install Back of Cab Screws)
Install
Fig. 2.8 (Install Front Mount Screws)
Torque nuts to
110 ft-lbs. (150 Nm)
Fig. 2.9 (Tighten Vehicle Frame Bolts, Left)
Left Brush
Right Brush
Fig. 2.10 (Install Brushes and Insert, Right)
14 of 34
Install
Insert
Advertisement
