Advertisement
STEP 1: (VEHICLE PREP CONT'D.)
1.11 Install Bracket and Spacer assembly from Step
1.10, on the outside of the right R.O.P.S. as well
as the sleeve and retainer with new M8X1.25 Nut
per fig 1.11. Leave hardware loose.
Hardware Used
M8X1.25 Lock Nut
Tools required
13mm socket and wrench
1.12 Re-install right fender removed from step 1.4. At
this time, leave hardware installed on step 1.11
loose. See Figure 1.12.
Tools required
T25 Torx Bit
10mm socket or wrench
13mm socket and wrench
1.13 Remove and set aside footrests (this includes
bolts, fender washers, and nuts). Next, remove
M10 Carriage bolt and nut found below brake
pedal. See Fig. 1.13.
Tools required
13mm socket and wrench
15mm socket
1.14 Remove (2) M10 lock nuts and washers from the
left side of the vehicle's caster arm per Fig. 1.14a.
Install front mount using the recently removed
M10 lock nut. Leave mounts loose per Fig. 1.14b.
Repeat on right side of vehicle.
Tools required
18mm wrench
19mm socket
Front Mount
Fig. 1.14b (Install Front Mount, Left Side)
CAB INSTALLATION
Qty
1
Curtis Bracket and
Spacer
Fig. 1.11 (Install Bracket & Spacer)
Fig. 1.12 (Re-Install Right Fender)
Remove + Set Aside
Footrests
Remove Bolt
and Nut
Fig. 1.13 (Remove Footrests & Brake Pedal Bolt)
Remove Washers
and Nuts
Fig. 1.14a (Remove M12 Washers and Nuts)
6 of 34
Retainer
& Sleeve
Right Fender
Advertisement
