Advertisement
STEP 1: (VEHICLE PREP CONT'D.)
1.24 Remove and set aside the (4) nuts and washers
holding the seat frame to the seat adjuster rails.
Next, remove frame from the seat. See Figure
1.24.
Tools required
13mm deep socket
1.25 Install (4) Clip-On Nuts using a socket to push
them onto the screws going through the (2)
adjuster rails. See Figure 1.25 with detail.
Hardware Used
M8X1.25 Clip-On Nut
Tools required
7/16" deep socket
Socket wrench extension
1.26 Place supplied seat pan assembly onto seat.
Next, re-install seat frame onto the seat pan.
Loosely install OEM washers and nuts back on.
Fully tighten left side hardware first followed by the
right side. See Figures 1.24 and 1.26.
Tools required
13mm deep socket
1.27 Install supplied release lever by pushing through
the underside of seat pans rubber filler. Placing
the hole of the lever onto the seat frame's latch
bar mounting bolt and the fork of the lever onto the
latch bar. Install lock nut onto the mounting bolt.
See Figures 1.26 and 1.27.
Hardware Used
M10X1.5 Hex Lock Nut
Tools required
17mm wrench and socket
Fig. 1.28 (Install Release Lever)
CAB INSTALLATION
Qty
4
Qty
1
Release
Lever
Remove and Set Aside
Fig. 1.24 (Remove Seat Frame)
Install Clip-Nuts Here
Fig. 1.25 (Install (4) Clip-On Nuts)
Rubber
Filler
Release
Lever
Release
Lever's Goes
Outwards
Fig. 1.26 (Install Seat Pan Assembly)
10 of 34
Front
Left
Seat Pan
Mounting Bolt
Latch Bar
Seat Frame
Advertisement
