Advertisement
STEP 2: (CAB INSTALLATION)
2.23 Remove the (2) clips found on the sides of the air
cleaner mount and set aside. See Figure 2.23a.
Rotate both the elbow that houses the "Air
Restriction Indicator" as well as the body of the air
cleaner in the mount roughly 180 deg until it looks
like Figure 2.23b.
Tools required
Flat Head Screw Driver
2.24 Per Figure 2.24, install relocation bracket making
sure fender washers are placed between
relocation bracket and vehicle's bracket.
Hardware Used
5/16-18X1" Flange Hex Screw
.349 X 1.129 Fender Washer
5/16-18 Flange Lock Nut
Tools required
1/2" wrench and socket
2.25 Re-install reconfigured air intake per Figure 2.25.
Make sure air intake is pointed vertically. At that
point, re-install clips into the air cleaner's mount
removed on step 2.23. Fully tighten down hose
clamps found on the engine and air cleaner.
Make sure the extra part of the hose clamp
located on engine is pointing down away from the
fuel lines. If radiator cover was removed on step
1.8, re-install now.
Hardware Used
Use hardware set aside on step 1.8
Tools required
13mm wrench and socket
Fig. 2.25 (Install Reconfigured Air Cleaner)
CAB INSTALLATION
Qty
2
2
2
Air Intake
Must Point
Vertically
Air Restriction
Indicator
Remove +
Set Aside
Fig. 2.23a (Reconfigure Air Cleaner, Stock)
Air Intake
Air Restriction
Indicator
Fig. 2.23b (Reconfigure Air Cleaner, New)
Relocation
Bracket
Bracket
Fig. 2.24 (Install Relocation Bracket)
19 of 34
Air Intake
Mount
Fender
Washer
Advertisement
