Advertisement
STEP 1: (VEHICLE PREP CONT'D.)
1.31 Remove compressor (with guard) and tensioner
from the compressor mount (keep 3/8" hardware
with compressor). Support the compressor using
a bungee cord or rope. Do not ever use the hoses
to support the compressor or damage may occur.
Next, remove compressor mount from rear
shipping bracket. See Figure 1.31.
Tools required
1/2" socket and wrench
9/16" socket or wrench
5/16" Allen wrench
1.32 Install compressor mount on the upper right side
of the engine. Use hex head screws and
washers** on top holes and flange hex head
screws on back side bolts. Torque screws to 19 ft-
lbs (26 N-M). See Figure 1.32.
**Note: washers are required on the top holes
so bolt do not bottom out in the engine.
Tip: Start bottom back side screw before
placing the compressor mount on the engine.
Hardware Used
M8X1.25X25 flange hex screw
M8X1.25X40 hex screw
M8 washer
Tools required
13mm wrench and socket
1.33 Clean the vehicle frame rails on either side of the
floorboard. Apply P.S.A. D-Rubber (9PR09) to the
top surface of the frame rails. Apply along the
inner edge of the surface as shown in Figure
1.33.. Repeat for left side.
Tools required
Scissors
CAB INSTALLATION
Qty
2
2
2
Rear Shipping
Bracket
Tensioner
Fig. 1.31 (Remove Compressor Mount)
Fig. 1.32 (Install Compressor Mount onto Engine)
Apply Rubber
Here
Fig. 1.33 (Install Rubber to Vehicle's Frame, Right)
12 of 34
Compressor
Mount
Guard
Compressor
Hex Head Screws
+ Washer Here
Advertisement
