Advertisement
STEP 2: (CAB INSTALLATION)
2.31 Re-install the modified grille using (2) screws
removed on step 1.4 to secure the left side. See
Figure 2.31.
Hardware Used
Use hardware set aside on step 1.4
Tools required
T25 Torx Bit
2.32 Install Compressor Shroud onto right side of
vehicle using (2) screws removed from step 1.4
and (1) 5/16-18 screw. See Figures 2.32a and b.
Use the (3) holes found in the shroud as guides
for drilling the grille shown on Figure 2.32a. Apply
touch up paint to drilled holes.
Hardware Used
5/16-18X3/4" Flange Hex Screw
Use hardware set aside on step 1.4
Tools required
T25 Torx Bit
1/2" wrench or socket
Center Drill
9/32" Drill Bit
Drill
2.33 Per Figure 2.33, install hardware through shroud
into grille.
Hardware Used
1/4-20X5/8" Flange Hex Screw
1/4-20 Flange Lock Nut
Tools required
3/8" wrench or socket
7/16" wrench or socket
CAB INSTALLATION
Qty
1
Qty
3
3
Fig. 2.31 (Install Re-Worked Grille)
Drill
Grille
Here
Fig. 2.32a (Rear Screws for Mounting Shroud)
5/16-18
Screw
Here
OEM
Screw
Here
Fig. 2.32b (Front Screws for Mounting Shroud)
Install
Fig. 2.33 (Install Hardware into Shroud)
22 of 34
OEM
Screw
Here
Advertisement
