Focke- Wulf FW190
INSTALLING THE FUSELAGE SERVOS
Because the size of servos difer, you
may need to adjust the size of the precut
opening in the mount. he notch in the
sides of the mount allow the servo lead to
pass through.
Install the rubber grommets and brass
collets into all servos. Test it the servos
into the fuselage servo mounts.
Secure the servos with the screws
provided with your radio system.
1.
Rudder servo
THROTTLE SERVO ARM
INSTALLATION
Install adjustable servo connector in the
servo arm as same as picture below:
1.
14
.
Elevator servo
Elevator servo
Instruction Manual.
2.
.
Rudder servo arm
Minimum servo spec.
Torque : 6.0V: 157.00 oz-in (11.31 kg-cm)
7.4V: 179.00 oz-in (12.89 kg-cm)
INSTALLING THE RECEIVER SWITCH
Install the switch into the precut hole in
the side, in the fuselage.
1.
2.
Elevator servo arm
Elevator servo arm
3/32" Hole.
Trim and cut