Fluorescent Lamp - Toshiba PORTEGE M400 Maintenance Manual

4 Replacement Procedure
4

4.31 Fluorescent lamp

This system uses LCD modules from the following suppliers. The procedure for replacing
the fluorescent lamp is different for each LCD module. Refer to the appropriate procedure.
12.1-inch (XGA)
12.1-inch (SXGA+)
NOTE: - When working with a LCD module, always use a flat, grounded table.
4-80
Get user manuals: See SafeManuals.com
Type Part No.
G33C00037110
G33C00019210
- Handle the backlight unit in the environment without dust, such as on the clean
bench. Keep the worktable free from any screws or other material that may
scratch the LCD surface.
- Use an anti-static or protective sheet.
- When replacing the FL unit, cover with a finger protector or similar to prevent
soiling or scratching the LCD panel.
- Be careful when handling the lamp. Excessive force may break the lamp.
- Be careful not to soil or deform the lamp reflector.
- Make sure that the power of the LCD module is turned off before connecting or
disconnecting cables and connectors.
[CONFIDENTIAL]

4.31 Fluorescent lamp

Supplier
TMD
TMD
PORTEGE M400 Maintenance Manual (960-541)
Section
4.31.1
4.31.1