Toshiba PORTEGE M400 Maintenance Manual page 124

3 Tests and Diagnostics
Select the option you want to execute and press Enter. When you select 1- SYSTEM
TEST, the following message will appear:
NOTE: The menu displayed by your computer may be slightly different from the one
Select the desired subtest number from the subtest menu and press Enter. The following
message will appear:
Use the right and left arrow keys to move the cursor to the desired option.
Selecting YES of TEST LOOP increases the pass counter by one, each time the test cycle
ends and restarts the test cycle.
Selecting NO returns the process to the subtest menu after the test is complete.
3-6
Get user manuals: See SafeManuals.com
Functions 1 through 12 are the Diagnostic Tests. Function 88 sets the floppy disk
drive and hard disk drive error retry count (0-255).
To exit the submenu of the Diagnostic Test and returns to the Diagnostics Menu, set
the highlight bar to function 99 and press Enter.
SYSTEM TEST NAME
SUB-TEST : XX
PASS COUNT : XXXXX
WRITE DATA : XX
ADDRESS : XXXXXX
SUB-TEST MENU :
01 - ROM checksum
02 – Fan ON/OFF
03 - Geyserville
04 - Quick charge
05 - DMI read
99 - Exit to DIAGNOSTIC TEST MENU
shown above.
TEST LOOP : YES (or NO)
ERROR STOP : YES (or NO)
[CONFIDENTIAL]
3.2 Executing the Diagnostic Test
XXXXXX xxxxxxx DIAGNOSTIC TEST VX.XX
[Ctrl]+[Break] : test end
[Ctrl]+[C]
ERROR COUNT : XXXXX
READ DATA : XX
STATUS : XXX
PORTEGE M400 Maintenance Manual (960-541)
: key stop