Toshiba PORTEGE M400 Maintenance Manual page 293

4.19 MDC
4. Turn up two points of insulator and disconnect the MDC cable from the connector
Installing the MDC
The following describes the procedure for installing the MDC. (See Figure 4-35 and 4-36.)
1. Connect the MDC cable to the connector CN4100 on the system board and wrap it
2. Connect the MDC cable to the connector on the MDC.
3. Install the MDC to the connector CN3010 on the system board and secure it with the
PORTEGE M400 Maintenance Manual (960-541)
Get user manuals: See SafeManuals.com
CN4100 on the system board.
Insulator
Figure 4-36 Removing the modem cable
with insulator.
following screws.
• M2.0×4.0B
MDC cable
CN4100
×2
BIND screw
[CONFIDENTIAL]
4 Replacement Procedures
4-55