Bridge Media Slot Troubleshooting; Procedure 1 Check On Windows Xp Tablet Pc Edition; Procedure 2 Connector Check And Replacement Check - Toshiba PORTEGE M400 Maintenance Manual

2.15 Bridge media Slot Troubleshooting

2.15 Bridge media Slot Troubleshooting

To check if the Bridge media slot is good or no good, follow the troubleshooting procedures
below as instructed.
Procedure 1
Insert a Bridge media into the slot. Check if the installed Windows XP Tablet PC Edition
recognizes automatically the Bridge media card and the data in the Bridge media card can be
read.
If the card is not recognized or data are not read, go to Procedure 2.
Procedure 2
The Bridge media is connected to the connector IS2101 of the system board.
Bridge media supports SD memory card/SDIO card/Memory stick/Memory stick Pro/
xD Picture card.
Check 1
Check 2
Check 3
PORTEGE M400 Maintenance Manual (960-541)
Get user manuals: See SafeManuals.com
Procedure 1: Check on Windows XP Tablet PC Edition
Procedure 2: Connector Check and Replacement Check
Check on Windows XP Tablet PC Edition
Connector Check and Replacement Check
Bridge media and system board may be disconnected. Make sure the Bridge media
is firmly inserted to IS2101 on the system board. If not, insert it firmly. If the
Bridge media is still not functioning properly, perform Check 2.
Bridge media may be faulty. Replace it with a new one following the step in
Chapter 4 Replacement Procedures. If the problem continues, perform Check 3.
System Board may be faulty. Replace it with a new one following the step in
Chapter 4 Replacement Procedures.
2 Troubleshooting
[CONFIDENTIAL] 2-51