Settings - LINET LINIS SafetyPort Instructions For Use Manual

11.4.3 SETTINGS

The SETTINGS section consists of three subsections:
► General
► SafetyPort Data Transfer Settings
► SafetyPort Dashboard setting
Fig. Settings
GENERAL
The GENERAL section is used to enter the Hospital name and set up the metric system.
Data transfer SETTINGS
The Data Transfer Settings section is used to enter the IP Address number, Port number and Sync Period in minutes.
This means LINIS SafetyPort will send data to the dedicated IP address and Port if CHANGED from last value, or if the
last value was sent x minutes(sync period) ago.
In case you chose the synchronous communication mode, you can also see the length of the data queue waiting to be
accepted by the endpoint here.
D9U001SW2-0110_03 25/52