Table of Contents
Advertisement
Validate a transaction setup
What is transaction setup validation
When you have defined, changed, or imported a transaction setup, you can validate the
transaction setup to check its media definitions. The validation procedure is performed for the
active PDL.
When you use the [Validate] option, the printer checks for each tray if the media definition is
valid. It depends on the tray selection mode ([Tray to media] or [Tray to tray]) how the media
elements are checked.
Validation in [Tray to media] mode
The printer checks the following:
• The media set per tray are available in the media catalog.
• The media print mode set per tray is defined for the media family of the media.
Validation in [Tray to tray] mode
The printer checks the following:
• The media families of the assigned media in the paper trays must have the IPDS media print
mode.
Validate a transaction setup
1. Open the Settings Editor and go to: [Transaction printing]→[Transaction setups].
2. Click [Validate].
The transaction setup is opened so you can adjust its attributes.
[180] [Transaction setups] menu
3. The report appears.
4. Read the report.
5. Click [OK] to close the report.
More information
Define the tray-to-media mapping on page 133
•
Define the tray-to-tray mapping on page 134
•
Define media in the media catalog on page 277
•
Define a media print mode on page 286
•
Assign media from media catalog to paper trays on page 99
•
Read the transaction setup validation report on page 147
•
VarioPrint i-series MICR
Validate a transaction setup
Chapter 7 - Transaction printing
145
Advertisement
Table of Contents
