Table of Contents
Advertisement
Clean the inner side of the print belt
Action
7
Fasten the two bolts to lock the cleaning plate.
8
Close the upper and lower doors of the print module. The print belt starts to run for ap-
proximately 3 minutes.
9
When the control panel indicates that the print belt has stopped, open the lower and upper
front doors of the print module.
10
Turn the two bolts in a counter-clockwise direction to unlock the cleaning plate.
11
Remove the cleaning plate and remove the cleaning cloth from the cleaning plate.
12
Check the pollution on the used cloth to determine if a new cleaning cycle is required.
13
• To start a new cleaning cycle touch [Continue] on the control panel.
- Repeat step 4 to 12 to clean the print belt again with a new cleaning cloth.
• To finish the print belt cleaning touch [Finish].
14
Close the upper and lower doors of the print module.
15
Touch [Confirm] on the control panel.
After you finish
Dispose the used cleaning cloths.
486
Chapter 13 - Maintain the printer
VarioPrint i-series MICR
Advertisement
Table of Contents
