Table of Contents
Advertisement
Load media into the paper module
Action
7
Slowly turn the knob clockwise until the side
sliders touch the stack without damaging it.
8
Squeeze the green handle of the front slider to
move the trailer-edge sliders carefully against
the stack without damaging it.
9
Take the next stack of media. Do not load more
than 500 sheets (80 g/m² / 20 lb bond) at the
same time.
Paper trays 1 and 2 can hold one ream (approxi-
mately 500 sheets (80 g/m² / 20 lb bond)). Paper
trays 3 and 4 can hold three reams.
Carefully put the new stack on the already loa-
ded stack without adjusting the sliders.
10
11 Gently push the paper tray back until it clicks in-
to place.
NOTE
It can happen that damaged or deformed sheets come on the paper path. The sentry is able to
detect these imperfect sheets and purge them to the sentry tray. There are guidelines how to
prevent sentry tray output.
106
Chapter 6 - Job media handling
IMPORTANT
Ensure that the loaded media stack does not exceed the loading limit mark on the
back slider.
Then the loaded media stack is maximum 63 mm / 2.48" (paper trays 1 and 2) or
181 mm / 7.13" (paper trays 3 and 4).
VarioPrint i-series MICR
Advertisement
Table of Contents
