[400] Output profiles
The list of output profiles can contain composite output profiles and Device Link profiles for
device simulation.
You can create new output profiles with PRISMAprofiler.
The maximum C, M, Y, and K color values (expressed in ∆E) are used as calibration target during
the media family calibration.
Rendering intents on the printer
When source colors fall outside the gamut of the printer, the rendering intent determines how
these colors must be reproduced.
Source colors that fall outside the gamut of the printer are being mapped into in-gamut colors,
often colors at the edge of the printer gamut.
[401] Rendering intents
More information
•
Learn about media elements on page 272
Create composite output profiles on page 344
•
Learn about color differences on page 412
•
Define an input profile on page 338
•
Define an output profile on page 341
•
Learn about transaction setups on page 125
•
Define a color preset on page 305
•
VarioPrint i-series MICR
Learn about input and output profiles
Chapter 11 - Manage color definitions
337