Control Connection - Extron electronics AXP 50 C AT Setup Manual

AXP 50 C AT • Setup Guide (Continued)

Control Connection

LAN — Using a standard Ethernet cable, connect to a network via one of the four AT ports (see
The control device must be connected to the same network. One of the four Ethernet ports can be dedicated as a control
connection. Communication between the AXP 50 C AT and a controlling device or software such as DataViewer is via a TCP
socket using port 4333. Dante controller displays the current IP address.
To find the IP address of a Dante device, the name of the device must be known (see
page 5).
Open Dante Controller for Windows (see
1.
From the toolbar, select Device>Device View.
2.
The Dante Controller - Device View dialog opens.
3.
Select your device from the (Select a Dante Device...) drop-down list.
Click the Network Config tab to open the network configuration page.
4.
The IP address, subnet mask, and gateway are shown.
5.
Dante Controller - Device View (AXP50-063f70)
Write down the address for use in the control device or DataViewer and use port 4443 to connect to the AXP 50 C AT.
2
Dante Network Setup
AXP50- 063f70
AXP50-063f70
AXP50-Podium
AXP50-Lecture Hall
AXP50-ConfRm 01
AXP50-ConfRm 02
DMP128-Rack #1
DMP128-Lecture Hall
DMP128-Rack #2
AXP50-063f70
AXP50-063f70
192 168 254 254
255 255 0 0
0 0 0 0
figure 1
Rename an AXP 50 C AT:
on page 5).
D
on page 1).
on