Titan TT5MTP26-2 Manual page 64

Care and maintenance
Carburetor
The carburetor has been carefully set at the factory. Adjustment may be necessary if
you notice that the engine will not idle (i.e the cutting attachment keeps moving when
the throttle is released). Contact an authorised service centre or dealer to do idle speed
adjustment.
WARNING! Keep others away when making idle speed adjustment. Keep
cutting attachment off the ground and out of contact with any object. The cutting
attachment will be running during this procedure. Wear protective equipment
and observe all safety precautions.
1. Release throttle and allow engine to idle.
70
2. Use a single D screwdriver (not provided) to turn the idle speed screw clockwise
to increase engine speed if engine stalls or dies (Fig. 70).
3. Use a single D screwdriver (not provided) to turn idle speed screw counter-
clockwise to decrease engine speed if the cutting attachment moves (Fig. 70).
64
Idle speed screw Idle speed screw
Single D Single D
screwdriver screwdriver
TT5MTP26-2