Titan TT5MTP26-2 Manual page 33

TT5MTP26-2
Assembling the attachment to the drive shaft tube
1. Remove the protective cap (B1/ C1/ D1/ E1) from the attachment to be used.
2. Pull out and rotate the locking knob (A17) on the shaft clamp (A16) anticlockwise
to stop at the bracket. Insert the shaft tube (B3/ C3/ D2/ E3) of the attachment into
the upper drive shaft tube (A13) (Fig. 18).
3. Release the locking knob (A17) by turning clockwise. Rotate and slide the upper
drive shaft tube (A13) inward until the locking knob (A17) snaps into place.
4. Tighten the locking nut (A18) to secure the connection of the tubes.
NOTE: The extension shaft can only be used with the pole pruner to allow for
longer reach. Tighten the attachments together using the shaft clamp (E4),
locking knob (E5) and locking nut (E6) of the extension shaft.
18
A16
A17
A18
Before you start
33