Titan TT5MTP26-2 Manual page 25

TT5MTP26-2
3. Poise the guide bar (C6) near the drive sprocket to fit the rest of the saw chain (C7)
around drive sprocket (Fig. 4).
4
4. With the saw chain (C7) fitted around the drive sprocket and the guide bar (C6),
carefully place the guide bar (C6) on the chain tension pin (Fig. 5).
5
5. Refit the clutch cover (C11) and tighten the fixing nut (C12) with the spring washer
using the multi-tool III (F3).
NOTE: Always check the saw chain tension before use, after the first cuts and
regularly during use, approx. every five cuts. Upon initial operation, new chains
can lengthen considerably. This is normal during the break-in period and the
interval between future adjustments will lengthen quickly.
C6
C7
C7
Drive sprocket
C6
Before you start
Drive sprocket
Chain tension pin
25