Titan TT5MTP26-2 Manual page 59

TT5MTP26-2
P25-2 by M a c A llis te r
M4MTP25-2 by M a c A llis te r
> File at an angle perpendicular to the bar, and at an angle of 30° to the direction of
travel (Fig. 62).
> File each tooth from the inside towards outside only. File one
side of the chain first than turn the saw around and repeat the
> File each tooth from the inside towards outside only. File one side of the chain first
process.
than turn the saw around and repeat the process.
> File each tooth from the inside towards outside only. File one
> Sharpen each tooth equally by using the same number of
> Sharpen each tooth equally by using the same number of strokes.
side of the chain first than turn the saw around and repeat the
strokes.
> Keep all cutter lengths equal. Check the safety depth gauge height every 5 sharpenings.
process. > Keep all cutter lengths equal. Check the safety depth gauge
If the depth gauges are also trimmed it is essential that the original profile be restored.
height every 5 sharpenings. If the depth gauges are also
> Sharpen each tooth equally by using the same number of
> Use a depth gauge measuring instrument to check the height of the depth gauge.
trimmed it is ess ntial that the original profile be restored.
strokes.
Depth gauge measuring jigs are available from most reputable tool merchants
Use a depth gauge measuring instrument to check the
>
> Keep all cutter lengths equal. Check the safety depth gauge
(Fig. 63).
height of the depth gauge. Depth gauge measuring jigs are
height every 5 sharpenings. If the depth gauges are also
available from most reputable tool merchants. (See Fig. 27c)
trimmed it is ess ntial that the original profile be restored.
> Use a depth gauge measuring instrument to check the
height of the depth gauge. Depth gauge measuring jigs are
available from most reputable tool merchants. (See Fig. 27c)
> Inspect the air filter regularly. Replace it with a new one if
necessary.
> Open the air filter case (A5) with the cross-head screwdriver
(E1), and remove the filter. (See Fig. 28)
62
Left-hand cutter
63
Cutting tip
File position
Top plate
Depth gauge
Ma in te n a n c e a n d R e pa ir s
Ma in te n a n c e a n d R e pa ir s
Sharpening angle
25-30°
25°
25°
File direction
Outside
Inside
Saw chain direction
Fig. 27b
Fig. 27b
Depth gauge setting
Cutter 1.27 mm(0.050")
length
Fig. 27c
Fig. 27c
Care and maintenance
59