Titan TT5MTP26-2 Manual page 53

TT5MTP26-2
Trimming
> Cut and remove branches exceeding the cutting capacity of this machine using a
suitable pruner before operation.
> Always hold the machine firmly with both hands on the rear handle (A9) and hand
grip (B2). Never operate this machine using only one hand.
> Cut both sides from the bottom cutting upwards to the top. This will prevent any of
the cuttings falling into the path of the area still to be cut (Fig. 53).
53
B2
> After cutting the sides proceed to the top.
> When cutting wide hedges with the cutting area in sight move the cutter blade
lightly through the cutting surface in a sweeping motion following the shape of the
hedge or shrub. A slight tilt downwards of the cutter blade in the direction of motion
is recommended for optimum cutting performance (Fig. 54).
> Move the machine with slow motion forward when cutting higher hedge and the
cutting area out of sight.
> Do not to rush and do not attempt to cut too much with one stroke of the cutter blade.
> Cut in a number of stages if the area being cut is particularly long to achieve a better
result; smaller cuttings will allow for easy composting.
54
A9
Operation
53