Hilti FX 3-A Operating Instructions Manual page 12

1.3 Product-dependent symbols
1.3.1 General symbols
Symbols used in relation to the product.
The power tool supports near-field communication (NFC) technology, which is compatible with
iOS and Android platforms.
Direct current (DC)
General warning symbol
1.3.2 Obligation symbols
Mandatory actions
Read the operating instructions
Wear protective gloves
Wear hearing protection
Wear eye protection
1.3.3 Warning signs
Hazard warning
Warning: Non-ionizing radiation
Warning: Magnetic field
Warning: Electric voltage
Warning: Flammable substances
Warning: hot surface
1.4 Product information
Hilti products are designed for professional use and may be operated, serviced and maintained only by
trained, authorized personnel. This personnel must be specifically informed about the possible hazards. The
product and its ancillary equipment can present hazards if used incorrectly by untrained personnel or if used
not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
Stud welding machine
Generation
Serial no.
1.5 Declaration of conformity
The manufacturer declares, on his sole responsibility, that the product described here complies with the
applicable legislation and standards. A copy of the declaration of conformity can be found at the end of this
documentation.
The technical documentation is filed here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistrasse 6 | D-86916 Kaufering, Germany
2 English
FX 3-A
01
2302420
*2302420*