Suzuki DF40A Manual page 49

• Apply water resistant grease to tilt rod upper bushings
(6), then install bushings in tilt rod.
Operate the PTT motor to extend the PTT rod upward.
Align the tilt rod with the hole in the swivel bracket as
the tilt rod extends.
: Grease 99000–25161 (SUZUKI Water
Resistant Grease (250 g))
6
• Apply water resistant grease to the PTT rod upper
shaft (7), then insert the shaft through the swivel
bracket and tilt rod.
Secure the upper shaft with the snap ring (8).
: Grease 99000–25161 (SUZUKI Water
Resistant Grease (250 g))
6
IBJ611220011-01
8
7
IBJ611220012-01
• Route the PTT motor cable in through the lower cover
and connect the PTT cable connector to the PTT
relay.
Refer to "Wiring Harness Routing Diagram": in
Section 4A in related manual.
• Final assembly check
Perform the following checks to ensure proper and
safe operation of repaired unit:
– All parts removed have been returned to their
original positions.
– Wire routing matchs service manual illustration.
Power Trim and Tilt: 2B-4
IAJ611220037-01