Suzuki DF40A Manual page 42

2A-16 Housing and Bracket:
3) Remove the snap ring (2) and push the tilt cylinder
upper shaft pin (3) out.
2
4) Remove the two bolts (4) securing gas cylinder lower
shaft to STBD/PORT clamp brackets.
5) Remove two STBD motor mounting bolts (5).
Using flat screw driver, drive locking edge of lock
washer (6) to clamp bracket side.
Loosen the clamp bracket shaft nut (7).
NOTE
Complete removal of the clamp bracket shaft
nut is not required.
Nut should only be loosened as far as the
end of the shaft threads to facilitate removal
of the tilt aid gas cylinder.
5
3
IBJ611210048-01
4
4
IBJ611210049-01
6
7
IBJ611210050-01
6) Slide the STBD clamp bracket (8) fully outward to
the right hand side.
Remove the tilt aid gas cylinder (9) and cylinder
lower shaft from between the clamp brackets.
Installation
Installation is reverse order of removal with special
attention to the following steps.
• Apply water resistant grease to the gas cylinder lower
shaft and lower shaft bushing.
Install the lower shaft bushing (1) and cylinder lower
shaft (2) to gas cylinder. Install the spacer (3) and (4)
to cylinder lower shaft.
: Grease 99000–25161 (SUZUKI Water
Resistant Grease (250 g))
3
1
2
• Apply water resistant grease to gas cylinder upper
bushings (5), then install bushings in cylinder upper
eyelet.
5
9
8
IBJ611210051-02
4
IBJ611210052-01
5
IBJ611210053-01