5) Disconnect the PTT motor cable wire connector from
the PTT relay. Cut the cable tie binding PTT motor
cable and trim sensor lead. Remove the PTT motor
cable from engine lower cover.
6) Remove the two bolts (4) securing PTT cylinder
lower shaft to STBD / PORT clamp brackets.
IAJ611220022-01
4
IBJ611220004-01
4
IBJ611220005-01
7) Remove two STBD motor mounting bolts (5).
Using flat screw driver, drive locking edge of lock
washer (6) to clamp bracket side.
Loosen the clamp bracket shaft nut (7).
NOTE
Complete removal of the clamp bracket shaft
nut is not required.
Nut should be loosened as far as the end of
the shaft threads only to facilitate removal of
the PTT unit.
8) Slide the STBD clamp bracket (8) fully outward to
the right hand side.
Remove the PTT unit (9) and cylinder lower shaft
from between the clamp brackets.
Power Trim and Tilt:
2B-2
6
7
5
IBJ611220006-01
8
9
IBJ611220013-01