Suzuki DF40A Manual page 39

• Tighten clamp bracket shaft nut (8) to specified
torque.
• After tightening clamp bracket shaft nut to specified
torque, bend lock washer edge toward nut to secure
nut.
Tightening torque
Clamp bracket shaft nut (a): 43 N·m (4.3 kgf-m,
31.0 lbf-ft)
8
• Tighten two PTT lower shaft bolts, pre-coated with
thread lock, to specified torque.
Tightening torque
PTT lower shaft bolt (b): 50 N·m (5.0 kgf-m, 36.0
lbf-ft)
: Thread lock cement 99000–32050 (SUZUKI
Thread Lock 1342 (50 g))
(b)
Steering Bracket
• Apply water resistant grease to steering bracket shaft.
: Grease 99000–25161 (SUZUKI Water
Resistant Grease (250 g))
NOTE
Apply grease to bushings, oil seal lip and
pilot shaft portion of steering bracket.
(a)
IBJ611210020-02
(b)
IBJ611210043-01
Housing and Bracket:
• Install upper bushing (1) and washer (2) to swivel
bracket.
• Install lower bushing (3) and swivel bracket seal (4) to
swivel bracket.
NOTE
Install bracket seal (4) with oil seal lip (spring
side) facing downward.
• Install steering bracket (5) to swivel bracket.
3
4
2
6
7
8
1. Upper bushing
2. Washer
3. Lower bushing
4. Swivel bracket seal
5. Steering bracket
Lower Mount Bracket
• Install lower thrust mount (1) to lower mount bracket
(2).
• Install washer (3) and shim (4), and then slide the
lower mount bracket (2) upward on the splines until it
contacts the shim.
1
2
2A-13
5
2
1
"A"
IAJ611210099-01
6. Shim
7. Lower mount bracket
8. Circlip
"A": Seal lip
3
4
IAJ611210100-01