Suzuki DF40A Manual page 34

2A-8 Housing and Bracket:
• Install washer (4) and lower mount nut (3), then
tighten two nuts, pre-coated with thread lock, to
specified torque.
Tightening torque
Lower mount nut (b): 60 N·m (6.0 kgf-m, 43.4 lbf-
ft)
: Thread lock cement 99000–32050 (SUZUKI
Thread Lock 1342 (50 g))
4
3
Mount Case Cover
• Apply water resistant grease to oil seal (1).
: Grease 99000–25161 (SUZUKI Water
Resistant Grease (250 g))
• Install the gasket (2), dowel pins (3) and mount case
cover (4), then tighten seven cover bolts securely.
3
2
3
(b)
IAJ611210065-01
3
IBJ611210065-01
1
4
IAJ611210067-01
Lower Mount Cover
• Install lower mount cover (1) and cover bolts (2), then
tighten bolts, pre-coated with thread lock, to specified
torque.
Tightening torque
Lower mount cover bolt (a): 50 N·m (5.0 kgf-m,
36.0 lbf-ft)
Water Pressure Valve
• Install water pressure valve (1) and cover (2).
Refer to "Water Pressure Valve Removal and
Installation": in Section 1F in related manual.
1
Bonding Wire
• Reattach the bonding wire (1), then tighten screw
securely.
2
(a)
1
IAJ611210068-01
2
I9J011210052-01
1
IAJ611210069-01