Suzuki DF40A Manual page 33

• Place upper mount / thrust mount assembly into
position.
NOTE
Position the retaining pin hole on upper
mount facing downward.
• Be sure the retaining pin "A" on the engine holder
properly fits into the retaining pin hole "B" on the
mount.
• Install the upper mount cover (7).
• Tighten upper mount cover bolts (8), pre-coated with
thread lock, to specified torque.
Tightening torque
Upper mount cover bolt (a): 50 N·m (5.0 kgf-m,
36.0 lbf-ft)
: Thread lock cement 99000–32050 (SUZUKI
Thread Lock 1342 (50 g))
"B"
"A"
IAJ611210059-01
IBJ611210031-01
7
8
(a)
IBJ611210032-01
Lower Mount / Bolt / Nut
• Assemble these items in the following sequence:
Place the forward damper (1), lower mount (2), side
lower mount (3) on lower mount bolt (4).
1
4
• Place the lower mount and bolt assembly into
position.
Upper Mount Nut and Lower Mount Nut
• Install the engine holder/ oil pan/ drive shaft housing
assembly to steering bracket.
• Install washer (2) and upper mount nut (1), then
tighten two nuts, pre-coated with thread lock, to
specified torque.
Tightening torque
Upper mount nut (a): 60 N·m (6.0 kgf-m, 43.4 lbf-
ft)
: Thread lock cement 99000–32050 (SUZUKI
Thread Lock 1342 (50 g))
2
Housing and Bracket:
2
3
IBJ611210033-01
IBJ611210034-01
1
(a)
IAJ611210064-01
2A-7