Assembly
Assemble the steering friction adjuster set in the
following sequence:
1) Install the washer (1), steering adjuster (2) and
washer (3).
2) Install the friction plate (4) and washer (5). Place the
spacer (A) onto the washer (5).
3) Install the washer (6), friction plate (7) and washer
(8), then temporarily tighten the nut (9).
4) Install the steering adjuster plate (10) and
temporarily tighten the two bolts (11), pre-coated
with thread lock.
6
5
4
10
3
11
2
"A"
9
8
7
"A"
1
IBJ611210016-02
5
IBJ611210062-01
Housing and Bracket:
NOTE
After temporarily tighten the two bolts (11),
confirm that the edge of washer (6) is located
between the punch marks "a" on the adjuster
plate (10).
" a "
5) Tighten the adjuster plate bolts (11) securely.
6) Move the steering adjuster lever to fully left position.
Tighten the nut (9) to specified torque.
Tightening torque
Nut (a): 5 N·m (0.5 kgf-m, 3.6 lbf-ft)
2A-19
10
" a "
IBJ611210063-02
9
(a)
IBJ611210064-01