Danfoss Control C.2 Operator's Manual page 52

Analog digital converter
Converts 0 - 400 bar in 0 – 27648 scale marks.
The machine motor is switched off after expiry of
the period set here.
Diameter pre-setting: When a new forming diame-
ter is entered, the diameter entered here is auto-
matically added to the forming diameter and ac-
cepted as switch point.
Screen: Number of forming processes up to this
time.
Pressure setting: When a new forming diameter is
entered, the diameter entered here is automatically
set for the forming pressure.
(PFM and PFC only) Time in milliseconds after
switchover during which the signal from the pres-
sure sensor is ignored (damping). This is intended
to mask out pressure peaks which may result by
the first material contact.
Return to previous screen.
Return to first machine settings screen (database).
Proceed to next screen.
Restore default settings.
To the operating system.
Closes the control software.