GeoVision V6 User Manual page 69

Troubleshooting
4
GV-Hot Swap Surveillance System V6 cannot be turned on.
If your GV-Hot Swap Surveillance System V6 cannot be turned on or you don't hear a startup
sound or any fan or drive noise, try these steps:
1. For 4U (20-bay) models, make sure that you switch on the AC power on the rear panel.
4U (20-Bay) Models
Figure 4-2
2. Make sure that the power cord is properly connected to both GV-Hot Swap Surveillance
System V6 and power outlet. If you are using a power strip, make sure that the strip is
powered on.
3. If the problem persists, consult your dealer.
GV-Hot Swap Surveillance System V6 stops responding ("crashed" or "frozen").
If your GV-Hot Swap Surveillance System V6 is not responding to your clicking, typing, or
mouse movements, try these steps to get your GV-Hot Swap Surveillance System V6 back on
track. Please note that you will lose any unsaved changes in all open applications.
1. Restart your GV-Hot Swap Surveillance System V6 by pressing the Reset button on the
front panel.
2. If your GV-Hot Swap Surveillance System V6 is still unresponsive, switch off the Power
button to shut it down. Wait 30 seconds and then restart your GV-Hot Swap Surveillance
System V6.
Figure 4-3
59