Table of Contents
Advertisement
Getting Started
3
3.9
Replacing the Hard Drive
You can replace the hard drive in the Hot Swap Drive Bay without shutting down the GV-Hot
Swap Surveillance System V6.
1. Make sure the HDD Activity LED (No. 2, Figure 2-5) is off.
2. Slide the release latch to the right. The drawer handle pops up.
3. Pull out the drawer slightly, and wait until the hard drive spins down.
4. Pull out the drawer completely, remove the hard drive, and then mount a new one.
5. Screw the hard drive, and make sure all screw heads flush with the surface.
6. Put the drawer back in the drive bay and slide the release latch again.
37
Advertisement
Table of Contents
