Additional Information On Working With Data Files - GE MFE DMS 2 Operating Manual

the SEND FUNCTION feature located in the RECORD
Submenu. (Note that there are additional send functions,
related to communication with external-devices, which can
be modified as explained in Chapter 6.)
Step 1: Open the Data Recorder by pushing
Step 2: Make sure that the data file you wish to work with is
active.
Step 3: Activate the RECORD Submenu by selecting it with
or so that it's highlighted. Selections will appear
across the bottom of the display screen including ITEM and
VALUE.
Step 4: Press below the selection titled ITEM. You'll
note that several file characteristics are listed including
SEND FUNCTION.
Step 5: Press below the selection titled ITEM until
SEND FUNCTION is highlighted.
DMS 2 Operating Manual
Step 6: Press
options are available:
THICKNESS ONLY – sends only the digital thickness
.
reading to the file position when
THCK / THCK+ASCAN – sends the digital thickness reading
and A-scan to the file position when
held. Sends only a thickness reading when
pressed and released.
THICK + ASCAN – sends thickness value and A-Scan with
all
Step 7:
chosen.
3.4.6 Additional Information on Working with Data
Files
Now that you've created a file, you're ready to collect and
record measurement data. Chapters 4 and 5 contain much
more detailed information on working with data files.
3. Setting Up the DMS 2
below the selection titled VALUE. Two
key presses.
's function will be set to the last option
is pressed.
is pressed and
is briefly
Page 85