GE MFE DMS 2 Operating Manual page 144

Deleting a Parameter Set
When you wish to remove or modify a saved a parameter
set, you must use the DELETE P-SET selection in the
PARAM Submenu. This is accessed from the TG Primary
Menu (Figure 3-4).
Step 1: Activate the PARAM Submenu (located in the TG
Primary Menu) by selecting it with
highlighted. Five selections will appear across the bottom of the
display screen.
Step 2: Press
below the selection titled P-SET. This will
display a list of all the saved parameter sets.
DMS 2 Operating Manual
or so that it's
Step 3: When the desired parameter set is displayed under
the P-SET selection, press and hold
titled DELETE P-SET. An audible signal will sound and the
saved parameter set to be deleted.
NOTE: There is no way to restore a deleted P-SET.
4. Measuring Thickness
below the selection
Page 133