GE MFE DMS 2 Operating Manual page 13

1. Getting Started
FIGURE 1-1—Install four AA alkaline batteries in the instrument as shown here.
Step 2: Select a compatible probe and plug its cable into the
top of the gauge as shown in Figure 1-2. Note that if you install
a single-element style probe, you won't be able to select the
dual measurement mode as specified in Step 3. (Refer to
Chapter 7 for probe selection.)
Step 3: Press to turn on the DMS 2. The TG menu will
be displayed with the TGMODE submenu accessed. Use the
Page 2
under each selection to choose the settings shown in
Figure 1-3. Note that if you've installed a DIALOG probe, the
instrument will automatically recognize it. (You may set the
instrument's time and date, at this point, by following the steps
in Section 3.2.2. Refer to Sections 3.2 and 3.3 for complete
setup instructions.)
DMS 2 Operating Manual