GE MFE DMS 2 Operating Manual page 159

5. Working with Stored Data
Step 2: Activate the STATS Submenu by selecting it with
or so that it's highlighted.
Step 3: Access the desired data file, if not already active, by
pressing below the FILE selection.
Step 4: Press below the STAT selection until the attribute
you wish to search for is selected. READINGS, EMPTY
POINTS, OBSTRUCTED POINTS, MIN READING, MAX
READING, A-scans, B-scans, and Micro-Grids can be tagged.
below the TAG selection until a ✔ appears
Step 5: Press
as shown in Figure 5-7.
Page 148
NOTE: Multiple attributes can be tagged as part of a given
search. Each attribute must be first identified with the STAT
selection, then tagged with the TAG selection (as described
above). However, not all attributes can be tagged. If an attempt
is made to tag a non-taggable attribute, no check will appear
next to it on the display screen. Refer to Figure 5-7.
Step 6: After all desired attributes have been tagged, press
below the SEARCH selection to launch a search. In the
SEARCH Mode, the user can navigate through a select set of
data points. Only those points that contain one or more of the
tagged attributes will be displayed while in SEARCH Mode.
Step 7: To exit the mode, press
QUIT SEARCH, which will only appear once the SEARCH
Mode is activated.
below the selection titled
DMS 2 Operating Manual