Emerson ASTEC Helios Candeo AP6C75AA Installation Manual page 79

The following illustration shows a typical example of stamping on the label
inside a Distribution Module. Note that the front cover of the Distribution
Modules are fully removable to ease the stamping procedures. If there are more
than one Distribution Modules, ensure that the front covers are not
interchanged.
Figure 6.2 – Typical stamping on the label inside a Distribution Module
Label
behind door
inside distribution panel
ATTENTION / CAUTION
SURFACES CHAUDES / HOT SURFACES
P1 P2 P3 P4 P5
Since the Helios Candeo is a front access power system there is no provision for
stamping at the rear of the Distribution Modules. If a second mean of
identifying distribution loads is required, plastic cable ties with a designation
card (such as in the following illustration) can be used on the distribution
conductors.
Figure 6.3 – Typical stamping tags for conductors
P6 P7 P8 P9 P10
PDC-01
FEEDER "A"
Helios Candeo Power System – AP6C75AA Installation Manual
End of job routines and turnover 79
P12
50 A
LC01
BAY
106.9
P11 P12 P13 P14 P15
Example of
designation
P16 P17 P18 P19 P20
AMPS
LOAD