Table of Contents
Advertisement
44 Cabling and connecting
•
•
•
Figure 4.1 shows typical cabling layouts for top-fed Helios Candeo power
system installations (note that your equipment may be different than that shown
in this illustration).
Figure 4.1 – Typical cabling layouts for top-fed Helios Candeo power system installations
System equipped with:
1 - Battery Connection Module
1 - large Distribution Module
1 - small Distribution Module
IM6C75AA P0914426 Standard 3.00 March 2001
The battery cables are entering the frame through the center, at the top for a
top-fed system, or at the bottom for a bottom-fed system.
The load cables to the protection devices and the battery return busbars
inside the Distribution Modules are entering the frame through the center, at
the top for a top-fed system, or at the bottom for a bottom-fed system.
The system alarm interface cable with the outside world shall always exit the
main cabinet on the left side, as viewed from the rear.
System equipped with:
1 - Battery Connection Module
2 - small Distribution Modules
Advertisement
Table of Contents
