Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS:
A
2. HORIZONTAL STABILIZER
Remove the molded tab at the end of the fuselage with a sharp knife (B). Slide the horizontal
stabilizer into the fuselage slot as shown (C). Make certain that the holes in the stabilizer line up
with the corresponding fuselage holes. If desired, a small amount of foam glue can be used for
maximum security.
B
3. VERTICAL STABILIZER & RUDDER
Install the vertical stabilizer and rudder
assembly into the slot in the fuselage. Please
make certain that the tail-wheel control wire is
located correctly in the plastic hole in the
rudder slot as shown (D).
If desired, a small amount of foam glue can be
used for maximum security.
1. UNDERCARRIAGE
Fix the undercarriage halves into position with the
four 2.6 x 12mm self-tapping screws as shown in ( A).
If the screws become excessively tight whilst fixing,
simply back them off a tum or two, and then continue.
Note: The undercarriage legs are angled towards the
front of the fuselage.
C
D
2
Advertisement
Table of Contents
